Hook a long tape measure up to your jib halyard (or top furling swivel on a furler see “Furler Hoist” below) just as if it were the head ring of the sail. Hoist it all the way until it stops at the top. Measure down to whatever point you intend to attach the sails tack to.
What is the J measurement on a yacht?
“J” is the base of the foretriangle measured along the deck from the headstay to the mast. “JC” is the greater of the following three dimensions: “J”, the length of the spinnaker pole, or the maximum width of the spinnaker divided by 1.8.
What do the numbers on a sail mean?
The numbers themselves usually don’t mean anything. Usually, the number is essentially “how many sails of this model have been produced before this one”. So, the first boat will have sail number 1, the 1000th will have sail 1000. Not all boats will come with numbered sails.
What is J measurement?
The joule (/dʒaʊl, dʒuːl/ jowl, jool; symbol: J) is a derived unit of energy in the International System of Units. … It is also the energy dissipated as heat when an electric current of one ampere passes through a resistance of one ohm for one second.
How big of a sail do I need?
The rule of thumb for the spinnaker size is the luffs = I. The foot should be between 1.6 x J and 2 x J. Many cruising boats are now using “Poleless Spinnakers.” The luff on poleless spinnakers should not exceed the I or the full size genoa luff. The foot should be between 1.6 and 1.8 x J.
How is mast height measured?
Mast height is almost always measured from the water. But to be sure you know the how high the top of your mast is from the water, measure the actual height of the mast from the deck to the top of the halyard (tape measure) and then add a foot to account for the sheeve typically being below the actual top of the mast.
What is a code 1 sail?
Code 1 is a light air reaching sail, where the apparent wind angles at low speeds has a significant effect to create angles of less than 90 degrees.
What is a code D sail?
Safety: Code D is an asymmetric sail specially designed to fit any furling system. Should wind increase or should there be an unexpected emergency, you just leave the sheet and in a few seconds it rolls up.
What is a code zero sail?
The Code Zero is a cross between a genoa and an asymmetrical spinnaker that is used for sailing close to the wind in light air. … The sail is very flat and is designed for close reaching. It has a nearly straight luff, a mid girth about 60-65% of the sail’s foot length.
What is a sail luff?
Luff -A sail’s forward edge. The luff of the mainsail is usually hoisted up and attached to the mast. The luff of the jib is attached to the forestay. Leech – The sail’s back edge.
How do you measure a spinnaker pole?
Spinnaker pole length: Rig the pole at a convenient height horizontally on the mast on the centreline of the boat. Ensuring that the pole is pulled forward to its maximum extension on the heel fitting, measure the distance from the front face of the mast to the extremity of the pole.
How big of a sailboat can one person sail?
So how big a sailboat can one person handle? Well, a sailboat measuring between 35 and 45 feet (10.5 – 14 meters) with a draft of about 2 meters, plenty of sail area, easy reefing, and well-working assistive equipment can be ideal for one person to handle.
How big of a yacht do I need to sail across the Atlantic?
Here’s How Big your Sailboat Should Be to Cross the Atlantic: For crossing the Atlantic Ocean, you should aim for a boat that is at least 30-40 feet long. An experienced sailor can do with less. The smallest sailboat to cross the Atlantic Ocean was just over 5 feet long.
How hard is it to sail across the Atlantic?
In short: it’s as hard you allow it to be.
So, in general, it’s not super hard. However, it can get pretty lonely at times. Being alone for 20+ days, with nothing but water and air, can take a toll on you mentally. Most sailors agree that this is the most difficult part of crossing the Atlantic.