How much does a jet ski key cost?

Make Difficulty New key cost
Sea-Doo Pre-2015 Medium $100 to $200
Sea-Doo Post-2015 Easy $70 to $150
Yamaha Easy $70 to $150
Kawasaki Medium $85 to $170

How much is a Jet Ski key?

The cost of a Sea Doo key replacement is going to vary depending on the model, the year, and the dealership. Most reasonable dealerships will charge between $25 and $50 for a replacement key.

How much does it cost to program a SeaDoo key?

The cost to replace your Sea-Doo key will depend on a number of factors, which include the year and model of your PWC, plus the dealership you turn to. Most dealerships will charge you anywhere from $50-$100, which would include the key replacement and the programming.

Do jet skis have keys?

Well before we can answer these questions, first we need to define what we mean by the word “key.” Most jet skis today actually have two different tools that are both referred to as keys, even though they have different functions: there are the “keys” that function as the security system for the jet ski, and there are …

IT IS INTERESTING:  What is the best kind of kayak to buy?

Can you start a SeaDoo without a key?

No, you can not bypass any Sea-Doo with a DESS key. … You can not start a Sea-Doo unless you have the key that is programmed to it!

Can you bypass SeaDoo Dess?

You cannot bypass the mpem to get a start on you boat. The DESS system was designed as an anti theft device.

How much does it cost to program a Dess key?

You don’t program the key, you program the sled to the key. The keys are about 35-40.00 usd depending on dealer. My dealer said they charge 15.00 to program.

What is a SeaDoo Dess key?

The SeaDoo DESS Key is the standard safety lanyard and security device that comes with a Seadoo jetski. DESS stands for ‘digital encoded security system’. The DESS Key contains a RF chip with a unique code that once paired with the ECU it has been programmed to, it will allow the ski to start.

Can you bypass Dess system?

As far as getting around the DESS, you can’t. It is programmed into the CDI box and the DESS post connects direct to it.

How do I get Sea Doo codes?

The procedure for retrieving codes is as follows:

  1. With safety lanyard on its post, press 5 times the SET button to start the display of P-codes (onboard diagnostic).
  2. Press MODE to scroll codes if more than one is present. When list is over, END will appear.
  3. When END appears, press MODE to exit.

How do you start a Seadoo?

Sea Doo iControl – 3 Starting Steps…

  1. Press the red start/stop button before doing anything else. This activates the computer, which signals “Welcome to Sea-Doo” on the centre of my gauge cluster.
  2. Promptly plug in my DESS cord. If it’s on properly, I hear two beeps.
  3. Depress the red start/stop button again – and bingo!
IT IS INTERESTING:  Your question: Where do you get the TM surf?

How do I clean my Dess key?

Clean your DESS key and post with a q-tip and rubbing alcohol. See if it helps.

How do I test my SeaDoo Dess key?

You should see continuity between both of the ground contacts in the side body of the key, and using the red test lead on either of the side ground contacts and the black test lead on the top center contact you should see less than 10 ohms of resistance on the IC serial chip.

On the waves