Each year we see lots of boaters pulling their tubes from wakeboard towers instead of a device rated for this activity. A universal safety rule in the aftermarket wakeboard tower industry is that boaters are forbidden to pull tubes from any aftermarket or OEM wakeboard tower.
Can you ski from a wakeboard tower?
You can use your wakeboard tower as a support beam to hold onto while maneuvering around the boat. Not only can you use the tower for wakeboarding, you can also use it for other water sports, including water skiing, kneeboarding, and wakesurfing.
Can you put a wakeboard tower on any boat?
All our universal wakeboard towers are designed to be adjustable and can fit just about any inboard boat made in the last 50 years. Aerial’s “universal” are carefully designed and tested so that strength and performance are not compromised when installed properly.
Is it easier to wakeboard with a tower?
However, a wakeboard tower does make it much easier to wakeboard, kneeboard or wakeskate. A wake tower gives much higher tow point that helps keep the tow line elevated.
How dangerous is wakeboarding?
When a person is pulled over his or her wakeboard, and hits the water headfirst, it is often a painful experience. Sometimes, the pain simply comes from a headache or water rushing up the nose, but there are times that the impact can bring on a headache, concussion or a painful whiplash.
Is it harder to water ski or wakeboard?
Wakeboarding is much harder and more complicated than waterskiing, but incredibly fulfilling once you get the hang of it! Plus, after you know how to waterski, then wakeboarding will be easier to learn. … Wakeboarding also has one thick shorter board for wakeboarding.
Can you Wakesurf behind any boat?
Inboard boats, including direct drives and V-drives, are the only types of boats you can safely wakesurf behind. … To recap, you should ONLY wakesurf behind an inboard board, never behind an outboard or inboard/outboard (stern drive) due to the risk of making contact with the propeller and the proximity of the exhaust.
What is the best speed for wakeboarding?
Tow Speed For Wakeboarding
The proper speed to tow a wakeboarder is usually between 15 and 25 mph. The bottom line when it comes to speed is that the faster you go, the cleaner and more firm the wake gets, making it easier and more consistent for riders trying to jump or learn new tricks.
How much does it cost to install a wakeboard tower?
What does it cost? † The wakeboard towers we install start at $1,500 installed. We will travel ANYWHERE to install a waketower on your boat wherever it is located. A minimum total installation order of $4,000 is required for travel.
Can you wake board without a tower?
You can wakeboard without a tower, but a tower offers a higher rope attachment at the boat stern, resulting in an upward rope pull for the wakeboarder. … Most wakeboarders start to wakeboard without a tower or extended pylon, however, and do just fine without it.
Do you need boots for wakeboarding?
Yes, shoes are an essential part of wakeboarding gear and are often referred to as bindings. Wakeboarding bindings are boots that are anchored to your wakeboard, allowing you to maintain your balance, ride waves and do tricks.
Can you ski behind a wakeboard boat?
If you want a wakeboard boat, you can use it for skiing, but the wakes won’t be as small as a direct drive. If you want to go wake surfing, you can use a wakeboard boat, but boats designed for wake surfing are better. Perhaps no other segment of the market is as targeted as tow boats.
How do you attach a tow rope to a ski pole?
The most secure procedure to attach a tow rope to the ski pylon is first place the loop end over the top of the pole and into the notch. Now grab the end loop end of the line and pull it forward so the line crotch or ” v” section of the line is pulled tightly against the ski pole notch.
How do you attach a tow rope to tubing?
The best way to attach a tow rope is to attach it to a fitting or “ski eyelet” on the center of the stern. HO Sports recommends boaters push the loop of the rope through the hole in the center of the tow attachment, and then wrap the loop around the perimeter of the tow harness.